How to Make a Wedding Cake

Why pay big money for an expensive, bakery-made wedding cake when you can easily build your own romantic creation at home? Though the prospect of creating a tiered cake may seem daunting, it is based on some pretty simple elements of architectural support. Like all sound construction, a tiered cake begins with a good foundation.

Foundation

For bottom cake tier, fill and frost the two largest cake layers in the center of a covered cake board that is about 4 inches larger than the cake, being sure to smooth frosting on top and sides. Use a sturdy cake board, such as 1/2-inch-thick plywood.SupportTrim two circles of corrugated cardboard sized to fit under the cake layers for each additional tier (total of 4 cardboard circles). Tape the two pieces for each tier together for a double thickness of cardboard.Cover the double-thick cardboard circles with foil that has been cut into a circle 1 to 2 inches larger than the cardboard. Center the cardboard on the foil. Cut slashes into the foil, spaced approximately an inch apart, around the entire circle. Fold each 1-inch tab of foil over the cardboard and tape into place.

Wrap the foil around the edgesof our cardboard circle.

Structure

To mark the correct position for the next tier, gently hold the foil-covered cardboard just above the center of the frosted bottom tier. Using a ruler as a guide, center the cardboard and gently lower it onto the frosted surface. Use a toothpick to lightly mark around the cardboard. Remove cardboard.

Gently lower your foil-wrapped circle onto the bottom layer.

To make dowel supports for this tier, carefully push a 1/4-inch-thick dowel into the center of the bottom tier and mark the height of the cake on the dowel. Remove the dowel and use clean pruning or other heavy-duty shears to cut the dowel on the mark. Cut seven more dowel pieces the same length. Push dowel pieces into the bottom tier, evenly spacing pieces within the area marked for the next tier and trimming the dowel pieces, if needed, to get them just level with the cake.

Push the dowel pieces into the bottom tier, evenly spacing pieces within the area marked for the next tier.

Since dowels are difficult to cut, you may use plastic straws to support each layer, if you stabilize the tiers with one large dowel as described.

Fill and frost cake layers for this tier positioned on the appropriately sized foil-covered cardboard circle; smooth frosting on top and sides of cake. Carefully place tier in position on bottom tier. Repeat for all tiers, supporting each layer with dowels.

To stabilize tiers, sharpen one end of a 1/4-inch-thick dowel with a knife. Push sharp end of dowel into center of top tier and carefully push down through all tiers and cardboard circles. Trim dowel level with cake top. Carefully smooth frosting on cake top to cover dowel. Remove dowel pieces before cutting cake.

Push the sharp end of the dowelinto center of top tier and carefully push down through all tiers and cardboard circles.

Decorations

Add your own creative touches with the decorations of your choice. Use a decorating bag to pipe on frosting borders and flowers, or apply premade decorations purchased from a cake decorating supply store or craft store. One of the simplest and most elegant ways to decorate a wedding cake is to use real fresh flowers. Be careful that the flowers don't have pesticides on them. Clean, fresh flowers should be placed on the cake right before it is displayed.